ET-TF II
- ET-TF-II Infusion Fluid Warmer is an indirect heating device (dry heat warmer)
- Can be used repeatedly with standard IV infusion tubing set
- Portable and easy to use
- No special training is required
- Setup can be finished in 1 minute at most
- Flow rate: 2 – 12ml/min (against temperature span: 25-41˚C)
- High accurate digital control for temperature
- Infusion fluid is regulated automatically to the set temperature in a short time
- Saving cost because no special disposable sets are needed
- ET-TF-II is just used with standard IV tubing
Stericare
- Safe and reliable, adopting reinforced protective insulation
- 3 level temperature measuring / calibration control to avoid deviation from the temperature setting
- Small size, convenient and easy to operate, may be used repeatedly
- Novel and streamline appearance design
- Adopting advanced PTC panel for quick and even heating
- Infusion liquid may be up to 26˚C – 35˚C only after 3-5 minutes of warming
- It may be directly connected to 110V or 220V
Fluid Warming Cabinet
- External surfaces manufactured from electro-galvanized and epoxy-coated mild steel
- Internal surfaces manufactured from brushed grade 304 stainless steel
- Easy and reliable operation
- Temperature control range: ambient temperature to 40°C (can be adjusted to other preferred settings)
- Fitted with an over-temperature sensor and a cut-out switch
